Submit an Article
Become a reviewer
Vol 189
Pages:
27-29
Download volume:
RUS
Article

The depth estimation of 2D conductive isometrical bodies by singular points at the tipper frequency characteristic

Authors:
E. Yu. Ermolin1
O. Ingerov2
About authors
  • 1 — post-graduate student Saint Petersburg State Mining Institute (Technical University)
  • 2 — vice-president of «PHOENIX GEOPHYSICS» LTD «PHOENIX GEOPHYSICS» LTD
Date submitted:
2010-07-29
Date accepted:
2010-09-02
Date published:
2011-03-21

Abstract

The relation between parameters of 2D anomaly body and features of vertical sections of tipper amplitude are considered in this paper. According to investigations the depth of center, top and bottom of conductive body is connected with geometrical distance between two symmetrically located positive extremes in tipper pseudo-sections. In addition the tipper amplitude in extremes decreases on account of increasing depth of anomalous body. The described regularities can be used for MT projects planning and quantitative estimation of anomalous body parameters using tipper pseudo-section constructed from field data.

Область исследования:
(Archived) Geology and geophsics
Keywords:
tipper induction arrows two dimensional structures
Go to volume 189

References

  1. Lam Н. et al. The response of perturbation and induction arrows to a three-dimensional buried anomaly // Geophysics 47, 1982. V.1. P.51-59.
  2. Rokityansky I.I. Geoelectromagnetic Investigation of the Earth's Crust and mantle. Springer-Verlag, Berlin, Heidelberg, New York, l982. 378 p.
  3. Ingerov O. et al. Hi sensitivity EM prospecting technique based on measurement of three magnetic components of
  4. natural EM field. 19th IAGA WG Workshop on Electromagnetic Induction in the Earth, Beijing. 2008. P.965-970.
  5. Ingerov O. et al. Non-grounded Surface Electroprospecting Technique., 70th EAGE annual Conference. 2009. Amsterdam.

Similar articles

The model of productivity of forest land
2011 V. F. Kovyazin, E. A. Lagutenko
Substantiation of pumped volumes of flow angularity compositions in injection wells
2011 A. R. Mavliev, M. K. Rogachev, D. V. Mardashov
Improving the efficiency of system of deleting waste on Udachny GOK
2011 V. P. Dokukin, A. A. Velnikovskiy
Development of the stowing material and testing of its mechanical properties
2011 M. N. Andreev, E. I. Boguslavskiy
Research of opencast reloading point’s influence оn bench turnover rate
2011 G. A. Kholodnyakov, M. M. Yakubovskiy
Efficiency klasterization оf the almazno-diamond complex of Russia
2011 A. K. Belov