Monitoring of condition, forecastingand increasing of residual resource of transmission and supported bearings of tubular furnaces
About authors
- 1 — Ph.D., Dr.Sci. professor Saint Petersburg State Mining University
- 2 — Ph.D. assistant lecturer Saint Petersburg State Mining University
- 3 — technical direktor «METKATOM» Co
- 4 — general direktor «Techpartner» Co
Abstract
The reasons of an emergency stop of tubular furnaces is destruction of bearings in support of the furnace, bearings and cogwheels in mechanical transmission, failure the electric motor, infringement of integrity of the case of the furnace and it brickwork. In article possibilities on forecasting of a residual resource of bearings of support and transmission are considered, principles of construction of a complex from system of monitoring of a condition and automatic systems of greasing of bearings are offered.
Область исследования:
(Archived) Automation of technological processes аnd manufactures in mining and processing industries
Funding:
None
References
- Artemev A.A., Potapenko V.S., Ivanov S.L., Krem-cheev E.A.,Poddubnaja A.A., Fokin А.С. To a question of an estimation of a resource of elements of transmissions of mountain cars // Mountain cars and electromecanics.2007.N9. P.31-35.
- Ivanov S.L., Dudko P.P., Dmitriev G.Ju, Podhalju-zin S.P. Automatic the centralized systems of greasing. Experience of application, the Problem and use prospect //Problems of mountain-transport systems and electromecan-ics.Saint Petersburg, 2008.P.22-26.
Similar articles
Pyrometallurgical selection of copper-zinc materials
2011 A. K. Orlov, G. V. Konovalov, A. J. Boduen
The electrothermal complexes influence on quality of the electric power in the isolated and deafly earthed neutral networks
2011 E. A. Zagrivny, D. A. Ustinov, V. I. Malarev, E. E. Vasilievа
Character determination of fusion mode оf sulphidic material in the gas-jet rotation devise
2011 S. A. Mirvaliev, A. N. Telyakov, V. V. Napsikov, S. N. Saltykova, N. M. Telyakov
The calculation of the kinetics of chemical and metallurgical processes for the purpose of the control at use of the interval method
2011 I. I. Beloglazov