Physical aspects of matelcutting in the local influence
Authors:
About authors
- Ph.D. associate professor National Mineral Resources University (Mining University)
Abstract
The article describes the physical aspects of the machining blanks in the preliminary local thermal impact on the material are examined, they allow to operate the process of shaving segmentation at the mashing on the lathes.
Область исследования:
(Archived) Manufacturing machinery and equipment
Funding:
None
References
- Weitz V.L., Maksarov V.V. Localization and instability of plastic deformation during the chip formation in metal cutting // Mechanical Engineering and Automation. N.13. Saint Petersburg, 1999. P. 39-43.
- Weitz V.L., Maksarov V.V. Physical principles modeling of chip formation during cutting // Mechanical Engineering and Automation. N.13. Saint Petersburg, 1999. P.44-46.
- Weitz V.L., Maksarov V.V., Lonza P.A. Dynamicsand modeling of cutting for machining. Irkutsk, 2000. 189 p.
- Livshits L.S. Metallography for welders. Moscow, 1979. 243 p.
Similar articles
Evaluation of the vibration processes of mechanical systems at the stage of their design in mechanical engineering
2014 D. Y. Ershov
Internal elastically inertial vibration protection of rotari machines
2014 V. P. Uvarov, L. B. Alexeeva
Modeling simulation of structure in a heat-affected zone of welded joint from low-alloyed steels
2014 E. I. Pryakhin, D. M. Sharapova
Analysis of the environmental situation in the place parking lots and parking in Saint-Petersburg
2014 E. G. Tsyplakova