Submit an Article
Become a reviewer
Vol 209
Pages:
42-46
Download volume:
RUS
Article

Technological capabilities of inverter power source for gas metal arc welding

Authors:
S. A. Ermolin1
A. S. Tarasov2
About authors
  • 1 — Ph.D. associate professor National Mineral Resources University (Mining University)
  • 2 — Ph.D. associate professor National Mineral Resources University (Mining University)
Date submitted:
2013-09-15
Date accepted:
2013-11-26
Date published:
2014-07-18

Abstract

The article is about an inverter power source used in the industry (a current up to 500 A, a duty cycle up to 60%, an inverter frequency not below 20 kHz) for the gas metal arc welding. There technical and technological advantages over the thyristor rectifier are discussed.

Область исследования:
(Archived) Manufacturing machinery and equipment
Keywords:
welding inverter power source metal spattering technology
Funding:

None

Go to volume 209

Similar articles

Method of operative analysis of the technical condition of the car
2014 A. V. Terentiev, B. D. Prudovskiy
Physical aspects of matelcutting in the local influence
2014 D. Y. Timofeev
Effect of design parameters of the front-end equipment of the mining shovels load on dynamics
2014 S. Yu. Kuvshinkin
Evaluation of gas parameters in explosive type displacement pumps
2014 A. B. Nezametdinov, M. G. Menzhulin, S. V. Khokhlov, P. V. Shishkin
Modeling and control of dynamical properties of the technological systems
2014 V. V. Maksarov, P. V. Leonidov
Validation of transport-tractor unit passability by organogenic deposits development
2014 A. V. Telego, A. V. Mikhailov, A. V. Bolshunov