Testing the electric motors with new moisture-resistant insulation of submersible motor-pumps with a capacity of Q = 30 m3/hour
Abstract
The present work is the result of creative collaboration of the Department of Mining Electrical Engineering of the Leningrad Mining Institute with one of the coal trusts. Electric motors of two submersible motor-pumps were tested. The design data of both motor-pumps are absolutely identical. Only their electrical parts differ slightly: the stator of the electric motor of one of them (motor-pump No. 7) has slightly larger slot dimensions than the stator of the electric motor of the other motor-pump (motor-pump No. 9). Therefore, 16 wires are laid in each slot of the stator of the electric motor of motor-pump No. 7, and 11 wires are laid in the electric motor of motor-pump No. 9. The main data of the submersible motor-pumps with a star connection of the stator winding of the electric motor are as follows: electric motor power on the shaft Pn = 9.2 kW; voltage Un = 380 V; revolutions n = 2900 rpm. Three-phase asynchronous short-circuited electric motor (Fig. 1); pump capacity Qn = 30 m3/hour; pump head Na = 50 m. The total height of the motor-pump is 1400 mm, the height of the electric motor is 930 mm, the diameter of the unit is 183 mm. The electrical and mechanical parts of the submersible motor-pumps are manufactured by the assembly and mechanical workshops of the trust. Submersible motor-pumps of the proposed design, used for pumping water from wells, compare favorably with those currently existing in the following features.