Submit an Article
Become a reviewer
Vol 236
Pages:
125-132
Download volume:
RUS ENG
Article
Geology

AMT soundings in the dead band within the Chukotka region (Russian Far East)

Authors:
E. Yu. Ermolin1
O. Ingerov2
A. A. Yankilevich3
N. N. Pokrovskaya4
About authors
  • 1 — Ph.D. генеральный директор J M Service Ltd.
  • 2 — Ph.D. Торонто
  • 3 — Ph.D. Leading engineer Saint-Petersburg Mining University
  • 4 — engineer Saint-Petersburg Mining University
Date submitted:
2018-11-10
Date accepted:
2019-01-17
Date published:
2019-04-23

Abstract

The article analyzes the amplitude spectra of audio magnetotelluric sounding (AMTs) data. Particular attention is focused on the frequency range from 1 to 5 kHz, which is called dead band. We analyzed the data of base stations used in the fieldwork during the summer and autumn seasons in 2013, 2014, and 2017. The area of work is located in the Chukotka Autonomous Area beyond the Arctic Circle. Previous researchers noted that a reliable signal in the dead band can only be obtained at nighttime. The authors of the article found that in Chukotka region in the daytime against the minimum signal within the dead band there is a local maximum at a frequency of 2.4 kHz. When registering a field for more than 3 hours during daytime, in most cases, it is possible to restore the frequencies of 2.2 and 2.6 kHz. These frequencies are reliable benchmarks, allowing in some cases to restore the AMT curve using the correlation between amplitude and phase. We have proposed ways to improve data quality in the dead band when measured during the daytime.

Область исследования:
Geology
Keywords:
audio magnetotelluric sounding (AMT) geomagnetic variation (GM) electromagnetic monitoring dead band epithermal gold-bearing quartz veins
Funding:

None

10.31897/pmi.2019.2.125
Go to volume 236

Similar articles

Structural model and tectonic evolution of the fault system in the Southern part of the Khur area, Central Iran
2019 A. Sohrabi, A. Nadimi, I. V. Talovina, H. Safaei
Development and research of formation technologies on specialized presses with subsequent sintering of high-density details from iron-based powders
2019 A. M. Dmitriev, N. V. Korobov, A. Zh. Badalyan
Low-density cement compositions for well cementing under abnormally low reservoir pressure conditions
2019 N. I. Nikolaev, E. L. Leusheva
Determining the stability of the borehole walls at drilling intervals of loosely coupled rocks considering zenith angle
2019 P. A. Blinov
Features of elementary burst formation during cutting coals and isotropic materials with reference cutting tool of mining machines
2019 V. V. Gabov, D. A. Zadkov, Khac Linh Nguyen
Refined assessment of seismic microzonation with a priori data optimisation
2019 I. B. Movchan, A. A. Yakovleva