Submit an Article
Become a reviewer
Vol 71 Iss. 2
Pages:
92-108
Download volume:
RUS
Article

Investigation of bottom-hole process in hard rock drilling in case of partial exposure of diamonds on the drill bit face.

Authors:
S. N. Tarakanov
Date submitted:
1975-08-18
Date accepted:
1975-10-09
Date published:
1976-02-01

Abstract

General remarks about the downhole process under study. A modern diamond impregnated crown can work downhole in two different modes: in perfect and imperfect diamond exposure at the face of the crown. This provision applies not only to impregnated and multilayer crowns, but also to single-layer crowns operating under forced feed ...

Область исследования:
(Archived) Without section
Go to volume 71

References

  1. Volosyuk G.K. Efficiency of borehole drilling with small-diameter tools. Exploration and Protection of Subsoil, 1969, № 3.
  2. Petrov I.P. Automatic regulation of drilling rigs operation. In the book: Improvement of Technique and Technology of Exploratory Drilling. M., Nedra, 1968.
  3. Technology and technique of exploratory drilling. Moscow, Nedra, 1973. Authors: F.A.Shamshev, S.N.Tarakanov, B.B.Kudryashov, Y.M.Pariysky, A.M.Yakovlev, E.A.Salie.

Similar articles

Condition of limit state of a rock rock
1976 V. A. Padukov
Expediency of using high-grade clay powders in drilling wells in the conditions of the North-East and Far North of the USSR.
1976 A. M. Yakovlev, V. G. Vartykian, A. V. Golovkin, V. V. Makhotin, E. A. Darda, E. M. Budyko
Justification and selection of the method of control over the frozen soil structure preservation when working out the drilling parameters of engineering-geological wells.
1976 V. I. Kovalenko, I. S. Afanasiev, V. I. Vasiliev
Investigations of heater shape influence on rock drilling-melting rate
1976 V. K. Chistyakov, V. A. Chugunov
Prospects of development of technology and technique of geological exploration drilling for solid minerals
1976 F. A. Shamshev
On the role and main directions of technical progress in geological exploration drilling
1976 Yu. M. Parijsky