Submit an Article
Become a reviewer
Vol 71 Iss. 2
Pages:
38-41
Download volume:
RUS
Article

Justification and selection of the method of control over the frozen soil structure preservation when working out the drilling parameters of engineering-geological wells.

Authors:
V. I. Kovalenko
I. S. Afanasiev
V. I. Vasiliev
Date submitted:
1975-08-29
Date accepted:
1975-10-12
Date published:
1976-02-01

Abstract

For engineering geology it is very important to take samples of soil with undisturbed structure. Especially difficult in this respect is the sampling of monoliths from frozen soils in the process of borehole sinking. In order to work out the technology of drilling wells in frozen soils, experiments were set up, in the course of which the main difficulty was the choice of the method of control over the state of structure preservation in the process of drilling ...

Область исследования:
(Archived) Without section
Go to volume 71

References

  1. Akimov A.T. Electrical resistivity of frozen rocks. DAN USSR, vol. 16, № 8, 1937.
  2. Nersesova Z.A. Instructional guidelines for determining the amount of unfrozen water and ice in frozen soils. Materials on laboratory studies of frozen soils. Coll. 2. PH of the Academy of Sciences of the USSR, 1954.
  3. Nersesova Z.A. Calorimetric method for determining the ice content of soils. Materials on laboratory research of frozen soils. Coll. 1. PH of the USSR Academy of Sciences, 1953.

Similar articles

Use of synthetic superhard material Elbora-B in rock-destroying drilling tools
1976 F. A. Shamshev, G. A. Senkin, L. K. Gorshkov
Importance of lubricating additives in diamond drilling
1976 A. M. Yakovlev
Experimental stand for investigation of borehole stability during drilling in glacial cover
1976 V. K. Chistyakov, V. M. Pashkevich
Condition of limit state of a rock rock
1976 V. A. Padukov
Investigation of bottom-hole process in hard rock drilling in case of partial exposure of diamonds on the drill bit face.
1976 S. N. Tarakanov
Analytical determination of rational axial load on a cutter crown
1976 Yu. E. Budyukov, I. E. Slyusar