Selection of some machine parameters for drilling directional wells of long length
Abstract
Modern cone drilling machines for drilling wells from the surface are capable of drilling vertical or inclined wells up to 320 mm in diameter and up to 30 m deep. In the underground development of deposits are used wells drilled at any angle to the horizon, and machines for their drilling provide penetration of wells with a diameter of up to 105 mm and a length of no more than 100 m.
Область исследования:
(Archived) Without section
Funding:
None
References
- Balitsky V.P. - Drilling and Drilling Equipment. M., Nedra, 1964.
- Grigoryan A.M. Stripping of strata by multihole and horizontal wells. M., Nedra, 1969.
- Kalinin A.T. Well Curvature. M., Nedra, 1974.
- Elnyashevskiy I.V., Orsulyak Y.M., Storonsky M.N. Typical tasks and calculations in drilling. M., Nedra, 1974.
- Epstein E.F. Calculation of drill pipes in geologic-exploration drilling. M., Nedra, 1979.
- Fedorov V.S. Design of drilling modes. M., Nedra, 1966.
- Fomenko F.N. Drilling of Wells by Electric Drill. M., Nedra, 1974.
Similar articles
Theoretical evaluation of teeth sliding influence on rock drilling efficiency by roller cone bits
1984 G. M. Kryukov, Ny Van Buck
Asymptotic small heat conduction solution of the Stefan problem of permafrost thawing in an electromagnetic field
1984 L. E. Rickenglaz