The paper discusses the issue of obtaining high quality cast workpieces of magnesium alloys produced by strip roll-casting. Producing strips of magnesium alloys by combining the processes of casting and rolling when liquid melt is fed continuously to fast rolls is quite promising and economic. In the process of sheet stamping considerable losses of metal occur on festoons formed due to anisotropy of properties of foil workpiece, as defined by the macro- and microstructure and modes of rolling and annealing. The principal causes of anisotropic mechanical properties of metal strips produced by the combined casting and rolling technique are the character of distribution of intermetallic compounds in the strip, orientation of phases of metal defects and the residual tensions. One of the tasks in increasing the output of fit products during stamping operations consists in minimizing the amount of defects. To lower the level of anisotropy in mechanical properties various ways of treating the melt during casting are suggested. Designing the technology of producing strips of magnesium alloys opens a possibility of using them in automobile industry to manufacture light-weight body elements instead of those made of steel.
In this article the problem of receiving high-quality cast strips from the magnesium alloys received by units of twin roll casting process in the combined methods is discussed. Production of sheets from magnesium alloys combination of casting and rolling at continuous giving of liquid melt to the rotating rolls is perspective and more economic method. Features of crystallization of magnesium alloys of AZ31 and AZ61 in a gap of rolls crystallizers depending on heat exchange conditions at change of technological parameters are considered. Due to impact on melt in forming system it is possible to provide formation of equal fine-grained structure of sheet hire without superficial defects. Development of the production technology of sheets from magnesium alloys creates possibility of their use of automobile branch as the facilitated details of bodies instead of the knots made of steel.
