Submit an Article
Become a reviewer
M. G. Mustafin
M. G. Mustafin
National Mineral Resources University (Mining University)
National Mineral Resources University (Mining University)

Articles

Mining
  • Date submitted
    2019-03-11
  • Date accepted
    2019-05-06
  • Date published
    2019-08-25

Estimation Method for Vector Field Divergence of Earth Crust Deformations in the Process of Mineral Deposits Development

Article preview

An essential requirement for effective and safe deposit development is good geomechanical software. Nowadays software packages based on finite element method are used extensively to estimate stress-strain state of the rock mass. Their quality use can only be assured if boundary conditions and integral mechanical properties of the rock mass are known. In mining engineering this objective has always been achieved by means of experimental observations. The main source of information on initial and man-induced stress-strain state of the rock mass is natural measurement of displacement characteristics. Measurement of geodetic data (coordinates, heights, directions) in the period between alteration cycles allows to plot a field of displacement vectors for the points in question. Taken together, displacement vectors provide information on the objective stress-strain state of the Earth crust. Basing on it, strain tensors, displacement components, directions and rates of compression and tension can be calculated in the examined area. However, differential characteristics of any physical vector field – namely, curl and divergence – need to be taken into account. Divergence is a single value (scalar) associated with a single point. Vector field as a whole can be described with divergence scalar field. Divergence indicates the sign (positive or negative) of volume changes in the infinitesimal region of space and characterizes vector flux in the nearest proximity and in all directions from a given point. In the paper authors propose a method to estimate divergence using discrete geodetic observations of displacement occurring on the surface of examined territory. It requires construction of formulas that model vector field for any point of the area. It is proposed to use power polynomials that describe displacement in three directions (x, y, z). These formulas allow to estimate field vectors in any given point, i.e. to form vector tubes. Then areas of input and output cross-section, as well as divergence values are calculated. This increases the quality of geodetic observation and provides opportunities for more precise modeling of the rock mass disrupted by mining operations, using modern software packages.

How to cite: Mazurov B.T., Mustafin M.G., Panzhin A.A. Estimation Method for Vector Field Divergence of Earth Crust Deformations in the Process of Mineral Deposits Development // Journal of Mining Institute. 2019. Vol. 238. p. 376. DOI: 10.31897/PMI.2019.4.376
Mining
  • Date submitted
    2018-03-03
  • Date accepted
    2018-05-02
  • Date published
    2018-08-26

TOPOGRAPHIC-GEODETIC AND CARTOGRAPHIC SUPPORT OF THE ARCTIC ZONE OF THE RUSSIAN FEDERATION

Article preview

A version of the project of the concept of topographic, geodetic and cartographic support of the Arctic zone of the Russian Federation based on the use of modern means and tools is presented, including its content. The results of the development in the Arctic, carried out with the participation of the authors in 1961-1967 and 1975-1992, are presented in detail. The strategic importance and great attention of the state structures to the development of the Arctic zone is underlined. The key moments of the development of topographic, geodetic and cartographic support for this region are given. The role of leading research institutes in this process is shown. The proposed concept includes six stages. When creating a planimetric geodetic base, the authors recommend an alternative innovative algorithm for determining the height H without first calculating the latitude B and use only satellite measurements. The extremely important question of converting geodetic coordinates B, L into rectangular plane coordinates x, y is considered. For the territory of the Russian Federation new developments are proposed, they use data from satellite determinations, a new approach to the determination of normal heights and the conversion of rectangular space coordinates into rectangular plane coordinates necessary for mapping. The required regulations of reference documentation for the topographic survey of the shelf are shown. The importance of implementing the concept in connection with the definition of the outer boundary of the continental shelf of the Arctic Ocean is shown.

How to cite: Mustafin M.G., Balandin V.N., Bryn M.Y., Matveev A.Y., Menshikov I.V., Firsov Y.G. TOPOGRAPHIC-GEODETIC AND CARTOGRAPHIC SUPPORT OF THE ARCTIC ZONE OF THE RUSSIAN FEDERATION // Journal of Mining Institute. 2018. Vol. 232. p. 375. DOI: 10.31897/PMI.2018.4.375
Mining
  • Date submitted
    2015-07-11
  • Date accepted
    2015-09-17
  • Date published
    2016-01-01

The mechanism of rock burst leading to ground destruction of mine openings

Article preview

The article deals with the main issues of studying of one type of rock bursts which lead to gound destruction of coal mine openings. The research is focused on rock burst prediction. Some cases of rock bursts are analised. The paper points out factors affecting this kind of rock failure. It also presents some simulation models and numerical examples. The results of the research show that it is possible to plan safe mining operations under different mining and geological conditions.

How to cite: Mustafin M.G. The mechanism of rock burst leading to ground destruction of mine openings // Journal of Mining Institute. 2016. Vol. 217. p. 40.
Mining
  • Date submitted
    2014-12-28
  • Date accepted
    2015-02-21
  • Date published
    2015-06-01

Modeling of rock massif geomechanical state at gas extraction from coal seams

Article preview

The article describes the method of modeling a coal seam stress-strain state and an enclosing rock massif when degasified. An approach to defining the model input parameters, calculated with the porosity and gas pore pressure coefficient, was shown. The importance of preliminary calculations, indicating possible coal seam shrinkage and surface subsidence was underlined. It shows formation mechanism for coal seam zones with elevated gas pressure, where gas recovery is efficient.

How to cite: Mustafin M.G. Modeling of rock massif geomechanical state at gas extraction from coal seams // Journal of Mining Institute. 2015. Vol. 216. p. 57.
Engineering geodesy
  • Date submitted
    2012-11-20
  • Date accepted
    2013-01-07
  • Date published
    2013-05-01

Application of terrestrial laser scanning for creation of three-dimensional models of Shukhov tower

Article preview

Application of terrestrial laser scanning for creation of three-dimensional models  of  Shukhov (Shabolovskaya) tower and determination of its  geometric  characteristics  is  considered. It helps increase the reliability of operation of the   facilities.

How to cite: Valkov V.A., Mustafin M.G., Makarov G.V. Application of terrestrial laser scanning for creation of three-dimensional models of Shukhov tower // Journal of Mining Institute. 2013. Vol. 204. p. 58.
Mine survey
  • Date submitted
    2012-11-14
  • Date accepted
    2013-01-25
  • Date published
    2013-05-01

Formation of technical areas rock burst in the coal seam

Article preview

Notes the importance of adjusting regulations to identify areas of high rock pressure in the modern conditions of development outburst coal seams. Partial results are estimates of changes in the width of the pressure depends on the length of output. The mechanism of the formation of technological outburst zones. Shows the software package to build a refined and unloading zones of high rock pressure.

How to cite: Mustafin M.G. Formation of technical areas rock burst in the coal seam // Journal of Mining Institute. 2013. Vol. 204. p. 62.
Mine survey
  • Date submitted
    2012-11-09
  • Date accepted
    2013-01-15
  • Date published
    2013-05-01

Characteristics of the strain-stress distribution of the quarry face with different curve

Article preview

The simulation results of the deformed state of rocks at the side of the open excavation with different forms. The technique of modeling. Emphasizes the importance of studying deformation processes taking into account nonlinearity circuit open excavation.

How to cite: Mustafin M.G., Panchenko A.V. Characteristics of the strain-stress distribution of the quarry face with different curve // Journal of Mining Institute. 2013. Vol. 204. p. 66.
Engineering geodesy and urban cadastre
  • Date submitted
    2011-11-04
  • Date accepted
    2012-01-20
  • Date published
    2012-05-01

Valuation of sustainable of pit wall based on data of digital photography of outcrop surfaces

Article preview

This article respond the method of determining the strength parameters of rock is considered a rapid assessment of the current state of stability mine array is   described.

How to cite: Mustafin M.G., Sannikova A.P. Valuation of sustainable of pit wall based on data of digital photography of outcrop surfaces // Journal of Mining Institute. 2012. Vol. 199. p. 276.
Engineering geodesy and urban cadastre
  • Date submitted
    2011-11-01
  • Date accepted
    2012-01-20
  • Date published
    2012-05-01

Definition of area harmful interference in communications construction underground

Article preview

Article is devoted to assessing and controlling the risk of deformation during the construction of pits in a densely built-up. Results of modeling the stress-strain state of the enclosing soil. Shows the organization of systematic observations of the deformation of the pit.

How to cite: Mustafin M.G., Naumov A.S. Definition of area harmful interference in communications construction underground // Journal of Mining Institute. 2012. Vol. 199. p. 281.
Engineering geodesy and urban cadastre
  • Date submitted
    2011-11-23
  • Date accepted
    2012-01-11
  • Date published
    2012-05-01

Application of radar scanning system GPRI-2 for monitoring the eath’s surface displacement

Article preview

The article provides a background to the implementation of monitoring ground displacement using radar scanning system GPRI-2. The advantages of this approach. Specific observations are made within the framework of monitoring  measurements.

How to cite: Mustafin M.G., Omarova A.K., Mozer D.V. Application of radar scanning system GPRI-2 for monitoring the eath’s surface displacement // Journal of Mining Institute. 2012. Vol. 199. p. 286.
Innovation in designing of mining plants
  • Date submitted
    2011-10-22
  • Date accepted
    2011-12-29
  • Date published
    2012-04-01

Using of spatial models оf objects for geodetic monitoring of deformation processes

Article preview

The paper presents comparison of classical methods of instrumental observations of slope stability with survey technology based on the use of laser  scanning systems,  as an  example of  the organization of monitoring the stability of the phosphogypsum stack Ltd «Balakovo mineral fertilizers».

How to cite: Mustafin M.G., Kovyazin A.V. Using of spatial models оf objects for geodetic monitoring of deformation processes // Journal of Mining Institute. 2012. Vol. 198. p. 191.
Innovation in designing of mining plants
  • Date submitted
    2011-10-05
  • Date accepted
    2011-12-17
  • Date published
    2012-04-01

Controls allowed earth deformation construction vertical openings in built-up area

Article preview

Article is devoted to predicting the effects of underground facilities  on  the  environment. The system of observations of the deformation of the earth's surface in the construction of the vertical development. Performed a preliminary analysis of the possible development of the deformation process. The comparison of calculated and actual data. Recommendations on the organization of the deformation  monitoring.

How to cite: Mustafin M.G., Naumov A.S. Controls allowed earth deformation construction vertical openings in built-up area // Journal of Mining Institute. 2012. Vol. 198. p. 194.
Innovation in designing of mining plants
  • Date submitted
    2011-10-15
  • Date accepted
    2011-12-29
  • Date published
    2012-04-01

Valuation of sustainable of pit wall

Article preview

This article respond the question about using the digital photographic data in  open-cast mine for specification of structural easing factor and his application for modeling of stsbility in open-cast mines with «Phase2» and  «NEDRA».

How to cite: Mustafin M.G., Sannikova A.P., Yushmanov P.I. Valuation of sustainable of pit wall // Journal of Mining Institute. 2012. Vol. 198. p. 198.
Problems in conservation of resources? mine surveying and wise erth's interior utilization
  • Date submitted
    2009-07-20
  • Date accepted
    2009-09-20
  • Date published
    2010-01-01

Problematic aspects in rock movement

Article preview

The paper considers the existing standards in the field of rock movement and protection of engineer constructions from harmful influence of mining operations. It is emphasized the necessity in revision of some standards in compliance with the real mining production.

How to cite: Mustafin M.G., Zelentsov S.N., Kuznetsova E.I., Rozhko A.A. Problematic aspects in rock movement // Journal of Mining Institute. 2010. Vol. 185. p. 227-230.
Physics and fracture mechanics rocks
  • Date submitted
    2006-09-13
  • Date accepted
    2006-11-22
  • Date published
    2007-03-01

Modeling of rock massive fracture in the process of moving of a cleaning face with different speed

Article preview

The influence of speed and discreteness of bottom-hole movement on deformation of rock massif and earth surface, on the character of rock massif shearing and the form of its destruction is considered.

How to cite: Mustafin M.G. Modeling of rock massive fracture in the process of moving of a cleaning face with different speed // Journal of Mining Institute. 2007. Vol. 171. p. 130-133.
Development regularities of technogenic and geological processes and phenomena
  • Date submitted
    2002-06-14
  • Date accepted
    2002-07-06
  • Date published
    2003-01-01

Prevention of dynamic destruction of solid rock layers in the soil of preparatory workings

Article preview

The approach to prediction and prevention of dynamic soil failure of preparatory workings is described. Mathematical modeling of the stress-strain state of the rock massif is used. An algorithm for solving a nonlinear problem, which is implemented in software complexes, is given. The mechanism of fracture of a solid layer in the excavation soil is shown. Practical recommendations are developed based on the results of the research.

How to cite: Mustafin M.G. Prevention of dynamic destruction of solid rock layers in the soil of preparatory workings // Journal of Mining Institute. 2003. Vol. 153. p. 88-90.