Submit an Article
Become a reviewer
M. A. Karasev, M. A. Buslova, M. A. Vilner, T. T. Nguyen (2019) Method for predicting the stress-strain state of the vertical shaft lining at the drift landing section in saliferous rocks. Journal of Mining Institute. Vol 240. p. 628. DOI: 10.31897/pmi.2019.6.628
KarasevM. A., BuslovaM. A., VilnerM. A., & NguyenT. T. (2019). Method for predicting the stress-strain state of the vertical shaft lining at the drift landing section in saliferous rocks. Journal of Mining Institute, 240, 628. https://doi.org/10.31897/pmi.2019.6.628

Method for predicting the stress-strain state of the vertical shaft lining at the drift landing section in saliferous rocks

Authors:
M. A. Karasev1
M. A. Buslova2
M. A. Vilner3
T. T. Nguyen4
  • 1 — Saint-Petersburg Mining University ▪ Orcid
  • 2 — Saint-Petersburg Mining University
  • 3 — Saint-Petersburg Mining University
  • 4 — Saint-Petersburg Mining University
Date submitted:
2019-06-05
Date published:
2019-12-25

Abstract

The article proposes a method for predicting the stress-strain state of the vertical shaft lining in saliferous rocks at the drift landing section. The paper considers the development of geomechanical processes in the saliferous rock in the landing area, the support is viewed as a two-layer medium: the inner layer is concrete, the outer layer is compensation material. With this in view, the paper solves the problem of continuum mechanics in a spatial setting, taking into account the long-term deformation of salts and the compressibility of the compensation layer. Long-term deformation of saliferous rocks is described using the viscoplastic model of salt deformation into the numerical model, and the crushable foam model to simulate the deformation of the compensation layer. This approach considers all stages of the deformation of the compensation layer material and the development of long-term deformations of saliferous rocks, which makes it possible to increase the reliability of the forecast of the stress-strain state of the vertical shaft lining.

Go to volume

Similar articles

Improving the efficiency of technological preparation of single and small batch production based on simulation modeling
2019 S. A. Lyubomudrov, I. N. Khrustaleva, A. A. Tolstoles, A. P. Maslakov
Development of Scada-model for trunk gas pipeline's compressor station
2019 Yu. V. Ilyushin, O. V. Afanaseva
Recent scientific research on electrothermal metallurgical processes
2019 E. Baake, V. A. Shpenst